I recently upgraded to a Snapmaker U1, though I think other modern printers have this feature as well. I was just printing a plate with multiple objects on it. Specifically I was printing a big squarish body of a tank, a few small pieces, and the tank cannon which was tall and skinny.
Mid-print, the cannon fell over - which was my own fault for not adding supports to it. The printer detected the print failure and stopped it, but that’s not the cool part. It allowed me to remove the object from the plate and continue printing the remaining objects! I figured I would have had to start the whole thing over again - wasting a ton of filament on the half completed tank body. Was super impressed!
You do need to enable tagging object in your slicer for this. But its absolutely something you should always do and it’s useful when needed.
You can also cancel parts of the print from the web interface, even with the gui showing you what part is what
Pretty cool!. What machine did you have before u1?
I had a Flashforge AD5X before. Still do actually, just as a second machine. It’s still a good printer, just poops a lot.
Just bought a U1 and havent had to use the feature yet but wish I’d had it on my old printer
It’s a software feature, so you can set it up on any printer you can throw klipper at.
I have it for my Ender 3 pro.
Does it work on Bambu printers?
Yes you can do this on Bambu printers as well! It can be done either from the app or the print screen.

Probably not, but idk. That’s what happens when you buy a closed-down system.
I know, right? I’d never heard anyone even mention it before, but it was a life saver!
I think people don’t even think about it anymore because it has been there for a few years now. My old cheap bedslinger has it too, not the automatic fault detection (because it doesn’t have a camera) but exclude by object has been a part of mainline klipper for 4-5 years now.


