nieceandtows@programming.dev to 3DPrinting@lemmy.worldEnglish · 2 days agoWhat does the bed mesh in Fluidd show? My prints are good, nothing to complain about, but I see the bed mesh doesn't look so good.programming.devimagemessage-square9linkfedilinkarrow-up114arrow-down10
arrow-up114arrow-down1imageWhat does the bed mesh in Fluidd show? My prints are good, nothing to complain about, but I see the bed mesh doesn't look so good.programming.devnieceandtows@programming.dev to 3DPrinting@lemmy.worldEnglish · 2 days agomessage-square9linkfedilink
minus-squarenieceandtows@programming.devOPlinkfedilinkEnglisharrow-up1·1 day agoIt’s an Ender 3 v3 CoreXZ. The filament sensor is on the right side. It is possible that when it reaches the right most side, it ‘bends’ the pfte/cables to its maximum and they put a strain? If so, how do I remedy it?
It’s an Ender 3 v3 CoreXZ. The filament sensor is on the right side. It is possible that when it reaches the right most side, it ‘bends’ the pfte/cables to its maximum and they put a strain? If so, how do I remedy it?